10″ long custom made flower pattern hand forged Damascus steel bar
Hand forged Damascus steel feather pattern bar.
Overall 10 inches long custom made bar.
Over 2 inches wide billet bar.
Custom made Feather pattern Damascus steel blade.
Approximately 3 mm Thick steel.
Blade is made of Damascus steel by forging the 1095 and 15N20 high and low carbon steel.
Our Damascus steel is prepared by forging over 200 layer of high carbon and low carbon steel.
Blade has been given an excellent heat treatment to get it well hardened.
Our tested hardness is 56 to 58 HRC – custom made flower pattern
Tips to Care Damascus knife:
Damascus steel as well as 1095 high carbon steel knives are different than some other common steel knives because of its high carbon content they can be rusted if not care properly. If you have seen rust accidentally then use WD40 to remove it.
Never store your knife for long time in leather sheath. Leather can absorb water which will rust the knife. Always clean the blade after using and apply oil or wax (please use cooking oil on Chef Knife) before you store it, for its longer life and durability – custom made flower pattern
Our knives are very sharp so open and use them very carefully.
We are not responsible for any injuries associated with the use of our knives.
Our products are intended for legal use only by responsible buyers.
We will not sell our products to anyone under the age of 18.
We will not be responsible for lost mail if wrong address is provided.
We will not be responsible for custom held items in your country (For international purchases only)